Today was productive. With the exception of putting two screws too far into the face frame and having to make a new piece for the entire top, things went well.
The new trim router and rabbeting bit were great for rabbeting out the back for the rear panel. I used the Dremel Saw Max to cut the 4x8 sheet of 1/4" oak plywood to size. I was happy with the ease of use. Cut quality wasn't the best but it got the job done fairly efficiently so I won't complain too loudly.
Got the face frame attached with pocket screws and the additional supports for the bottom cut and installed as well.
I think that I could have been close to finishing today. Hitches were an interview I had to conduct for a coaching position at the school and we had guests come in for the evening during the interview. Phenomenal people, my wife's friends from college out from Pittsburgh.
Hit it hard again tomorrow and I might have this thing done before church on Sunday!
Hit it hard again tomorrow and I might have this thing done before church on Sunday!
No comments:
Post a Comment